Stratus V6-2.5L VIN H (1997)
seal boot is sitting on seal groove in lower control arm.
3. Carefully position ball joint seal boot in seal retaining groove on lower control arm. After installing seal boot in retaining groove, carefully bleed
air out of sealing boot without getting grease pushed into seal boot retaining groove in lower control arm.
4. Place Retaining Ring Installer, Special Tool, 6875-1, or equivalent over ball joint seal boot. Using adjusting knob, adjust tool so bottom edge of
tool is even with top of retaining ring groove in seal boot.
5. Place seal boot retaining ring on Installer, Special Tool, 6875-1, or equivalent. Then place expandable collar from Installer, Special Tool, 6875
over tapered cone of the special tool.