Stratus V6-2.5L VIN H (1997)
Fig. 7
7. Attach routing bracket for speed sensor cable to brake flex hose bracket and securely tighten attaching bolt.
8. Install park brake cable into brake support plate. Ensure cable retainer is securely holding cable to support plate. Then connect park brake cable to
park brake lever on brake shoe.
9. Install rear hub and bearing assembly on knuckle and install hub and bearing assembly retaining nut. Tighten retaining nut to a torque of 250 Nm
(185 ft. lbs).
10. Install the brake drum on the hub/bearing assembly.
11. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in Proper sequence until all nuts are torqued to half specification.
Then repeat the tightening sequence to the full specified torque of 129 Nm (95 ft. lbs.).
12. Lower vehicle.
13. Check and reset rear wheel alignment to specifications if required.
