Stratus Coupe L4-2.4L VIN G (2003)
1. Disconnect column switch connector C-203 and measure the voltage available at the wiring harness side.
2. Measure the voltage between terminal 1 and ground.
-
The voltage should equal approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES : Go to Step 8.
NO : Go to Step 3.
STEP 3. Check the column switch connector C-203 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is column switch connector C-203 in good condition?
YES : Go to Step 4.
NO : Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Confirm the DTC 12 is not displayed.
