Stratus Coupe L4-2.4L VIN G (2003)
STEP 7. Check the combination meter power supply circuit to the combination meter. Test at combination meter connector C-101.
1. Disconnect combination meter and measure the voltage available at the harness side of the connector.
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage between terminal 12 and ground.
-
The voltage should measure approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES : Go to Step 10.
NO : Go to Step 8.
STEP 8. Check the combination meter connector C-101 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is combination meter connector C-101 in good condition?
YES : Go to Step 9.
NO : Repair or replace the damaged component(s). Refer to Harness Connector Inspection. See: Diagrams/Diagnostic Aids Verify that the low
washer fluid level warning light works normally.
