dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Information Bus|Description and Operation|Page 1843 > < Oscilloscope Test|Page 1839
Page 1
background image

Information Bus: Description and Operation

COMMUNICATION METHOD

As shown, signal wires used exclusively for transmitting multiplex signal data connect the ETACS-ECU, front-ECU, column switch (incorporating the
column-ECU) and sunroof motor assembly (incorporating the sunroof-ECU) and these components communicate with each other.

OPERATION

TONE ALARM FUNCTION

Ignition Key Reminder Tone Alarm Function

When the driver's door is opened (driver's door switch ON) without removing the ignition key [ignition switch to "LOCK" (OFF) or "ACC" position],
the tone alarm will sound intermittently to remind the driver that the ignition key has not been removed.

Light Reminder Tone Alarm Function

When the driver's door is opened (driver's door switch ON) with lighting switch (taillight switch or headlight switch) in the ON position and ignition
switch in the "LOCK" (OFF) or "ACC" position, the tone alarm will sound continuously to remind the driver that the lights (taillights or headlights) are 
ON. This function does not work if the taillights or headlights are switched 0ff through the headlight automatic shutdown function. In addition, the
ignition key reminder tone alarm function has a priority over this function.

Door Ajar Tone Alarm Function

If any of the doors are open, with ignition switch "ON" and with vehicle running at the speed of 8 km/h (5 mph) or more, ETACS-ECU makes buzzer
sound.

Low Washer Fluid Level Tone Alarm

If 10 seconds have passed after ignition switch has been turned "ON," and then, washer fluid level switch remains at the position "ON" (alarms for
washer fluid level getting low) for two seconds or more, ETACS-ECU makes buzzer sound.Buzzer sounds just once after setting ignition switch to the
position "ON."

Seat Belt Tone Alarm Function

When the ignition switch is turned to "ON" position without fastening the seat belts (seat belt switch OFF), the tone alarm will sound for approximately 
six seconds to warn the driver to fasten the seat belts. When the seat belts are fastened, the tone alarm will stop sounding.

Low Fuel Level Tone Alarm Function

If seven seconds have passed after ignition switch has been set to the position "ON," and then, low fuel level signal (low fuel level alarm light) from
ECM or PCM, is turned "ON," ETACS-ECU makes buzzer sound.Buzzer sounds just once after setting ignition switch to the position "ON."

CENTRAL DOOR LOCKING SYSTEM

Central Door Locking System Operation

-

When the driver's inside lock knob is locked or unlocked, the lock relay inside the ETACS-ECU turns on to lock or unlock all doors.

-

With all the doors locked, turning the key in the driver's door unlocks the door. Turning it again makes the door unlock relay close to send a signal
for unlocking all doors.

-

When the door lock switch (built into the power window switch) is operated, the lock or unlock relay inside the ETACS-ECU is turned on to lock
or unlock all doors.

Forgotten Key Prevention Function

Information Bus|Description and Operation|Page 1843 > < Oscilloscope Test|Page 1839