Stratus Coupe V6-3.0L VIN H (2001)
Use special tool, MB991219, to inspect the engagement of the male pins and female pins. [Pin drawing force: 1 N (0.2 pound) or more]
Connector Measurement Service Points
Turn the ignition switch to "OFF" when connecting and disconnecting the connectors. Turn the ignition switch to "ON" when measuring if there are no
instructions to the contrary.
IF INSPECTING WITH THE CONNECTOR CONNECTED (WITH CIRCUIT IN A CONDITION OF CONTINUITY)
Required Special Tool:
MD998459: Test Harness
Waterproof Connectors
Be sure to use special tool, MB991219. Never insert a test probe from the harness side, as this so will reduce the waterproof performance and result in
corrosion.
Ordinary (non-waterproof) Connectors
Check by inserting the test probe from the harness side. Note that if the connector (control unit, etc.) is too small to permit insertion of the test probe, it
should not be forced; use the backprobing tool for this purpose.
IF INSPECTING WITH THE CONNECTOR DISCONNECTED
<When Inspecting a Female Pin>
-
From front side of the connector
Required Special Tool: