Stratus Coupe V6-3.0L VIN H (2001)
1. To protect the body (paint surface), apply cloth tape to all body areas around the installed.
2. Using piano wire
1. Using a sharp-point drill, make a hole in the windshield adhesive.
2. Pass the piano wire from the inside of the vehicle through the hole.
3. Using a sharp-point drill, make a hole in the windshield adhesive.
4. Pass the piano wire from the inside of the vehicle through.
Caution: Do not let the piano wire touch the edge of the windshield.
5. Pull the piano wire alternately from the inside and outside along the windshield to cut the adhesive.
3. Using glass adhesive knife
1. Get glass adhesive knife.
Caution: Putting glass adhesive knife too deeply into windshield adhesive may damage windshield.
2. Keep glass adhesive knife at right angles with the windshield edge, and put the blade at the windshield edge and surface. Then cut away
adhesive along the windshield edge.
4. Make mating marks on the windshield and body.
5. Use special tool MB990480 to remove the windshield.
