Stratus Sedan L4-2.4L VIN X (2003)
Wheel Speed Sensor: Description and Operation
Wheel Speed Sensors and Tone Wheels:
One Wheel Speed Sensor (WSS) is located at each wheel. Each sensor sends a small digital signal to the control module (CAB). The CAB sends 12
volts to the sensor. The sensor has an internal magneto resistance bridge that alters the voltage and amperage of the signal circuit. This voltage and
amperage is changed by magnetic induction when a toothed sensor ring (tone wheel) passes by a stationary magnetic sensor (wheel speed sensor). The
CAB measures the voltage and amperage of the digital signals for each wheel.
The front wheel speed sensor is attached to a boss in the steering knuckle. The tone wheel is an integral part of the front axle shaft. The rear sensors
are mounted to the rear disc adapters. The rear tone wheels are pressed on the rear hub. The wheel speed sensor air gap is not adjustable.
The four wheel speed sensors are serviced individually. The front tone wheels are serviced as an assembly with the outer C.V. joint housing. The rear
tone wheels are serviced as an assembly.
Correct antilock system operation is dependent on tone wheel speed signals from the wheel speed sensors. The vehicle's wheels and tires should all be
the same size and type to generate accurate signals. In addition, the tires should be inflated to the recommended pressures for optimum system
operation. Variation in wheel and tire size or significant variations in inflation pressure can produce inaccurate wheel speed signals; however, the
system will continue to function when using the mini-spare.
