Stratus Sedan V6-2.7L (2001)
2. Coolant leaks; if the shaft seal is leaking, this will be evident by traces of thick deposits of dried glycol running down from the pump weep passage
and components below. A thin black stain below pump weep hole/passage is considered normal operation.
3. Impeller rubs inside of cylinder block.
4. Excessively loose or rough turning bearing.
NOTE: It is normal for the water pump to weep a small amount of coolant from the weep hole. Do not replace the water pump if this condition
exists. Replace the water pump if a heavy deposit or a steady flow of engine coolant is evident from the weep passage. This indicates a shaft seal
failure and pump must be replaced. Be sure to perform a thorough analysis before replacing water pump.
INSTALLATION
1. Clean all sealing surfaces.
2. Install water pump and gasket. Tighten mounting bolts to 12 Nm (105 inch lbs.).
3. Install timing chain guides, timing chain, and timing chain cover.
4. Reconnect negative battery cable.
5. Fill cooling system.
