Stratus Sedan V6-2.7L (2001)
Windshield Washer Reservoir: Service and Repair
Washer Reservoir Replacement
REMOVAL
1. Disconnect and isolate the battery negative remote cable.
2. Disconnect washer fluid hose at in-line connector on top of the right shock tower.
3. Partially remove bumper fascia as needed to gain access to the reservoir. Refer to Frame & Bumpers, Bumpers, Front Fascia, Removal.
Fig.2 Reservoir Removal
4. Disconnect wire connector from washer pump and harness mounting tab.
5. Remove washer reservoir mounting bolts.
6. Slide rearward and drop down and away from vehicle.
7. Drain washer fluid from reservoir into an appropriate container.
8. Disconnect the washer hose from the reservoir.
INSTALLATION
1. Connect the washer hose to the reservoir.
2. Install the washer fluid reservoir.
3. Connect wire connector to washer pump and harness mounting tab.
4. If fascia was partially removed, reinstall bumper fascia as needed. Refer to Frame & Bumpers, Bumpers, Front Fascia, Installation.
5. Connect washer fluid hose at in-line connector on top of the right shock tower.
6. Fill washer fluid.
7. Connect the battery negative remote cable.
