Stratus Sedan V6-2.7L VIN T FFV (2003)
Seat Heater Switch: Testing and Inspection
DIAGNOSIS AND TESTING - HEATED SEAT SWITCH
Refer to Wiring Diagrams for the location of complete heated seat system wiring diagrams.
WARNING: DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE
(GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE
PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
1. Remove the heated seat switch and inspect the connector for damage.
2. Unplug the 7-way connector from the switch and check the harness terminals for proper ignition voltage and ground. Refer to Wiring Diagrams for
complete heated seat system wiring diagrams.
JR Heated Seat Switch
3. Check the drivers switch for resistance between pin terminals PB and 86B. Resistance should match the specifications shown in the table, as the
switch is rotated from #0 - #6. If not OK, replace the heated seat switch.