Stratus Sedan V6-2.7L VIN T FFV (2003)
Clutch Pulley Install
4. Install pulley bearing assembly with Installer (6871 or equalvent). Thread installer on the shaft, then turn the nut until the pulley assembly is
seated.
5. Install external snap ring with the bevel side of the snap ring facing outward. Verify snap ring is seated.
CAUTION: If snap ring is not seated in the groove it will vibrate out and cause clutch failure and severe compressor damage will occur.
6. Install compressor with the original clutch shims on the compressor shaft.
Clutch Plate Driver
7. Install clutch plate with Driver (6463 or equalivent). Install the shaft nut and tighten to 14.4 Nm (10.5 ft. lbs.).