Viper GTS V10-488 8.0L (1998)
Throttle Position Sensor: Service and Repair
Fig. 34 Throttle Position Sensor
The TPS is attached to the left throttle body (Fig. 34).
REMOVAL
1. Disconnect the TPS electrical connector.
2. Remove the TPS mounting screws.
3. Remove the TPS.
Fig. 35 TPS Installation
NOTES:
-
The throttle shaft end of the throttle body slides into a socket in the TPS (Fig. 35).
-
When indexed correctly, the TPS can rotate a few degrees to line up the mounting screw holes with the screw holes in the throttle body.
-
If the sensor will not rotate into place, install the sensor with the throttle shaft on the other side of the socket tangs.
-
The TPS has slight tension when rotated to align the mounting holes.
INSTALLATION
1. Install TPS and mounting screws.
2. Attach electrical connector to the TPS.