Viper GTS V10-488 8.0L (1998)
NOTE: Prior to installing stop lamp switch into bracket, the plunger must be moved to its fully extended position using the procedure in Step 12.
12. Hold stop lamp switch firmly in one hand. Using other hand, pull outward on the plunger of the stop lamp switch until it has ratcheted out to its
fully extended position.
13. Install the stop lamp switch on the clutch brake pedal mounting bracket. Clip the stop lamp switch wiring harness to the clutch/brake pedal
mounting bracket.
14. Install the clutch master cylinder into the dash panel. The clutch master cylinder is installed by pushing it firmly into the dash panel and then
rotating it clockwise until it engages and locks into the clutch/brake pedal bracket on the inside of the vehicle.
15. Install the hydraulic clutch master cylinder actuation rod on the pin of the clutch pedal. Actuation rod is installed by carefully forcing the actuation
rod and retaining clip onto the pin on the clutch pedal.
16. Install the vacuum booster push rod on the brake pedal pin.
NOTE: When installing the retaining clip on the brake pedal pin a NEW retaining clip must be used to ensure the retention of the vacuum booster
push rod.
17. Install a NEW retaining clip on the brake pedal pin.