Viper GTS V10-8.0L VIN E (1999)
Locking Brake Shoe Retaining Pin Into Caliper
Rear Disc Brake Caliper Components
9. Using a pin drift, drive the brake shoe retaining pin into the caliper. Be sure retaining pin is installed until retaining pin snap ring is seated in
outboard side of caliper.
10. Install the wheel and tire. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the
tightening sequence to the full specified torque of 122 Nm (90 ft. lbs.).
11. Lower the vehicle.
