Viper GTS V10-8.0L VIN E (1999)
Wiper Switch: Service and Repair
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
1. Disconnect and isolate the battery jump start attachment.
2. Remove the tilt steering column lever.
3. Remove the knee blocker/lower steering column trim panel.
Steering Column Shrouds
4. Remove both the upper and lower shrouds from the steering column.
5. Remove the lower fixed column shroud.
6. Loosen the steering column upper bracket nuts. Do not remove the nuts.
Multi-Function Switch Connector
7. Move the upper fixed column shroud to gain access to the rear of the multi-function switch.
8. Remove the multi-function switch tamper proof mounting screws (a Snap On tamper proof Torx bit TTXR20B2 or equivalent is required).
9. Gently pull the switch away from the column. Loosen the connector screw. The screw will remain in the connector.
10. Unplug the wire harness connector from the multi-function switch.
11. Reverse the removal procedures to install. Tighten the fasteners as follows:
