Viper RT-10 V10-8.0L VIN E (1997)
9. Using a pin drift, drive the brake shoe retaining pin into the caliper. Be sure retaining pin is installed until retaining pin snap ring is seated in
outboard side of caliper. Refer to illustration to ensure that the rear caliper brake shoes and components are correctly installed.
10. Install the wheel and tire. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the
tightening sequence to the full specified torque of 122 Nm (90 ft. lbs.).
11. Lower the vehicle.