Viper SRT-10 V10-8.4L (2008)
Towing Information: Service and Repair
Towing
STANDARD PROCEDURE - TOWING
CAUTION: Towing with equipment other than flat bed types may damage your vehicle.
Do not tow with sling type equipment. Only use flat bed equipment. Always comply with applicable state or local towing ordinances.
To avoid damage to bumper fascia and air dams use of a flat bed towing device is recommended. If a flat bed device is used, the approach angle should
not exceed 15 degrees. Use only the reinforced elongated holes located in front of the front suspension on the side of frame rail to secure vehicle to flat
bed. Use only the reinforced elongated holes located rearward of the rear suspension on the side of frame rail to secure vehicle to flat bed. Secure vehicle
to flat bed at all four corners of frame to avoid towing damage.
WARNING: Do not allow towing attachment devices to contact the fuel tank or lines, fuel leak can result. Do not lift or tow vehicle by front or
rear bumper, or bumper energy absorber units. Do not venture under a lifted vehicle if not supported properly on safety stands. Do not allow
passengers to ride in a towed vehicle.
CAUTION: Do not damage brake lines, exhaust system, shock absorbers, sway bars, or any other under vehicle components when attaching
towing device to vehicle. Remove or secure loose or protruding objects from a damaged vehicle before towing. Refer to state and local rules and
regulations before towing a vehicle. Do not allow weight of towed vehicle to bear on lower fascia, air dams, or spoilers.
