Viper SRT-10 V10-8.4L (2008)
CAUTION: Hand start the bolt to prevent damage from cross-threading.
1. Install the ignition capacitor (2) to the engine block (3).
2. Install the ignition capacitor bolt (1) and tighten bolt to 10 Nm (88.5 in. lbs.).
3. Connect the ignition capacitor electrical connector (1).
4. Install the intake manifold. See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Removal and Replacement/Intake
Manifold - Installation
5. Connect negative battery cable. Tighten to 10 Nm (90 in. lbs.)
