Viper SRT-10 V10-8.4L (2008)
Ball Joint: Service and Repair
Front Lower Ball Joint Boot Seal
Removal
REMOVAL
NOTE: Review all Warnings and Cautions See: Service Precautions
1. Raise vehicle. See: Maintenance
2. Remove tire and wheel assembly. See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Removal
3. Remove brake caliper from knuckle and hang out of the way, then remove brake rotor. See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Brake Rotor - Removal
4. Remove bolt (3) fastening ABS wheel speed sensor head (2) to steering knuckle (1). Remove sensor head from knuckle.
5. Loosen, but do not remove, nut attaching stabilizer bar link (4) to lower control arm (5). Back off and position nut at end of link stud.
CAUTION: The nut must be positioned at the end of the stabilizer bar link stud to help prevent the end of the stud from being damaged when
separating it from the lower control arm.
6. Place center punch (3) in dimple on end of stabilizer bar link stud (4). Strike center punch with hammer, releasing link stud from lower control
arm. Remove nut (2).