W250 3/4 Ton Pickup 4WD V8-318 5.2L VIN T 2-BBL (1983)
Fig. 14 Typical disassembled view of Chrysler electronic 8 cylinder distributor (Dual pickup distributor similar)
4.
On eight cylinder units, if distributor housing, shaft, reluctor sleeve or governor weights are to be replace, proceed as follows:
a. Remove distributor shaft retaining pin and slide retainer off end of shaft.
b. If necessary, use a file to clean burrs from around pin hole area on shaft, then remove lower thrust washer.
c. Push shaft upward and remove from distributor housing.
Distributor Assembly