W 150 Pickup V8-360 5.9L (1984)
Ignition Switch: Service and Repair
Fig. 1 Lock cylinder removal. Less tilt steering wheel
MODELS LESS TILT STEERING
1.
Disconnect battery ground cable and remove turn signal switch as outlined in this chapter.
2.
Remove ignition key lamp assembly attaching screws, then the assembly.
3.
Remove snap ring from upper end of steering shaft.
4.
Remove bearing housing to lock housing attaching screws, then the bearing housing from the shaft.
5.
Remove buzzer switch attaching screws, then the buzzer switch, if equipped.
6.
Remove lock lever guide plate attaching screws, then the lock plate.
7.
Place lock cylinder in the "Lock" position and remove key. Using a suitable tool, depress spring loaded lock retainer and pull lock cylinder from
housing bore.
8.
Remove ignition switch attaching screws, then the ignition switch.
9.
Reverse procedure to install.
Fig. 2 Lock cylinder removal. W/tilt steering wheel
MODELS WITH TILT STEERING
Fig. 2 Lock cylinder removal. W/tilt steering wheel
Ignition Lock, Replace