W 150 Pickup V8-360 5.9L VIN W (1987)
FIGURE 2-C - INSTRUMENT PANEL WIRING
FIGURE 2-D - TERMINAL END OF FUSE BLOCK
Install the bare terminal (orange wire) from the instrument panel overlay harness into the previously vacated cavity in the ignition switch connector.
Reconnect the natural colored one way connectors supplied with the instrument panel overlay harness, and reconnect the ignition switch connectors
(Figures 2-B and 2-C).
3.
Replace the 5-amp fuse located in cavity #11 of the fuse block with the 10-amp fuse supplied in kit (Figure 2-D).
FIGURE 2-C - INSTRUMENT PANEL WIRING
4.
Route the instrument panel overlay harness along the existing instrument panel ignition switch wiring from the bulkhead connector and behind the
fuse block to the existing red mold connector and instrument panel ground terminal (Figure 2-C).