W 150 Ramcharger V8-360 5.9L (1991)
5.
Remove the terminal from cavity # 2 (See Figure 1).
6.
Insert the terminal from the harness, P/N 4773164, into cavity # 2.
7.
Install the wedge into the connector.
8.
Install the connector to the sending unit.
9.
Tie strap the harness along the chassis to the original harness following it into the engine compartment.
10.
Drill a 1/2" hole in the dash panel as shown in Figure 2.
11.
Route the harness through the hole and seat the grommet.
12.
Remove the knee blocker, the IP cluster and disconnect the cluster connectors.
13.
Route the harness through the dash to the cluster area.
14.
Remove the wedge from the cluster connector (See Figure 3) being careful not to break it.
15.
Remove the terminal from cavity F (AN Body) or A (AD Body). (See Figure 3).
