Concord L6-258 4.2L VIN C 2-bbl (1982)
Timing Cover: Service and Repair
1.
Remove drive belts, fan and pulley.
2.
Remove vibration damper.
3.
Remove oil pan-to-timing chain cover screws and cover-to-block screws.
4.
Raise the cover and pull the oil pan front seal up enough to pull the retaining nibs from the holes in the cover.
5.
Remove timing chain cover gasket from block. Cut off seal tab flush with front face of cylinder block. Clean gasket surfaces.
6.
Remove oil seal.
7.
Place gasket in position on cylinder block. Install new oil pan front seal, cut off protruding tab of seal to match portion of the original seal.
8.
Insert suitable aligning tool in cover seal bore and on crankshaft. Install cover-to-oil pan screws and tighten lightly. Install cover screws and
tighten.
9.
Retighten all screws and install new cover seal.
