Eagle Sedan L6-258 4.2L (1984)
FIGURE 2 - FRONT WHEEL BEARING ASSEMBLY
HUB AND BEARING CARRIER INSTALLATION - EAGLE MODELS
1.
Thoroughly clean axle shaft (20) (Fig. 2) and apply a thin coating of lithium grease. Install axle shaft-to-bearing spacer (18) (Fig. 2).
2.
Install rotor shield (16) to the bearing carrier (10) and hub (6), (Fig. 2). Coat O-ring (11) with grease and install it to the carrier assembly
3.
Apply Locktite, 812 9800, and install the three carrier bolts (17) (Fig. 2) tighten bolts to 102 N-m (75 ft.lbs.).
4.
Install caliper anchor plate to the steering knuckle. Tighten bolts to 136 N-m (100 ft.- lbs.) torque.
5.
Connect steering arm to steering knuckle. Tighten bolts to 136 N-m (100 ft.-lbs.) torque.