Summit Wagon AWD L4-1795cc 1.8L SOHC (1994)
Ignition Control Module: Testing and Inspection
NOTE: An analog-type circuit tester should be used.
Ignition Power Transistor
1. Connect the negative (-) terminal of the 1.5V power supply to terminal 5 of the ignition power transistor; then check whether there is continuity
between terminal 5 and terminal 12 when terminal 6 and the positive (+) terminal are connected and disconnected.
NOTE: Connect the negative (-) probe of the circuit tester to terminal 12
2. Replace the ignition power transistor if there is a malfunction.