Summit Wagon AWD L4-2350cc 2.4L SOHC (1995)
STANDARD WAVE PATTERN
Wave pattern observation points: Check to be sure that cycle time T becomes shorter when the engine speed increases.
EXAMPLES OF ABNORMAL WAVE PATTERNS
Example 1
Cause of problem - Sensor interface malfunction
Wave pattern characteristics - Rectangular wave pattern is output even when the engine is not started.
Example 2
Cause of problem - Loose timing belt, Abnormality in sensor disk
Wave pattern characteristics - Wave pattern jumps to the left or right.
With California Emissions
WAVE PATTERN INSPECTION USING AN ANALYZER MEASUREMENT METHOD
1. Disconnect the distributor connector and connect the special tool (test harness: MB991348) in between. (All terminals should be connected.)
2. Connect the analyzer special patterns pickup to distributor connector terminal 3. (in order to check the camshaft position sensor signal wave
pattern)
3. Disconnect the crankshaft position sensor connector and connect the special tool (harness MD998478) across the disconnected connector parts.
4. Connect the analyzer special patterns pickup to crankshaft position sensor connector terminal 2. (in order to inspect the crankshaft position sensor
signal wave pattern.)
ALTERNATE METHOD (TEST HARNESS NOT AVAILABLE)
1. Connect the analyzer special patterns pickup to ECM terminal 88. (When inspecting the camshaft position sensor signal wave pattern.)
2. Connect the analyzer special patterns pickup to ECM terminal 89. (When inspecting the crankshaft position sensor signal wave pattern.)