Summit Wagon AWD L4-2350cc 2.4L SOHC (1995)
Crankshaft Position Sensor: Service and Repair
Distributor Exploded View
NOTE: Crankshaft Position / Camshaft (TDC) Sensor are replaced as a complete unit.
REMOVAL:
1. Disconnect battery ground cable.
2. Remove distributor cap retaining screws and seal ring.
3. Place No. 1 cylinder to TDC of compression stroke. Place a mark on distributor body indicating position of rotor.
4. Disconnect wiring harness from distributor lead wire.
5. Remove distributor mounting nuts then the distributor assembly from engine.
INSTALLATION:
1. Turn the crankshaft so that the No.1 cylinder is at top dead center.
Distributor Drive Gear Alignment
2. Align the distributor housing and gear mating marks.