Talon AWD L4-1997cc 2.0L DOHC Turbo VIN F SMFI (1997)
3. Install the other end of the vacuum hose fully onto its port on the engine. Secure the hose using the hose clip.
4. Check clearance adjustment between brake booster push rod and primary piston.
Adjusting Clearance Between Brake Booster Push Rod And Primary Piston
a. Adjust the clearance (A) between the brake booster push, rod and primary piston as follows:
Calculating Clearance A From B With Straight Scale
Calculating Clearance A From C With Straight Scale
Calculating Clearance A From D With Straight Scale
b. Calculate clearance A from the B, C and D measurements. A = B - C - D
Standard value: 0.00 - 0.25 mm (0.00 - 0.010 inches)
NOTE: When brake booster negative pressure 67 kPa (9.7 psi) is applied, clearance value will become 0.1 - 0.3 mm (0.004 - 0.012 inches).
If the clearance is not within the standard value range, turn the push rod screw to achieve desired length.