Talon FWD L4-1997cc 2.0L DOHC (1990)
Note:
The new hinges are identified by the shallow notch (not deep notch) between the attachment slots (Figure 3).
6.
Place supplied template on glass inside of rubber seal and align as shown in Figure 4. Position the rubber hinge spacer and hinge in the template
cutout (Figure 4) and tighten the attachment screws to 24 inch-pounds. Repeat the procedure for the other hinge.
7.
Reinstall the sunroof glass panel to the vehicle.
8.
Check glass panel-to-roof panel fit and adjust if necessary.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.
Use the labor operation number and time allowance (see illustration).
Parts Return
Removed hinges must be returned to the Warranty Material Return Center.
Note:
See Warranty Policy and Procedure Manual, Chapter 6, Subsection H, for complete recall claim processing and material return instructions.
Vehicle Not Available
If a car is not available for this service for a known reason, let us know by filling out the pre-addressed Vehicle Disposition Form portion of the Owner
Recall Notification Form or describe the reason on a postcard and mail to:
Chrysler Motors 416-15-19
Recall Coordination
P.O. Box 1919
Detroit, Michigan 48231-9986
Following the above procedures will expedite the processing of your claim.
If you have any questions or need assistance in completing this action, please contact your Zone Service Office.
SAFETY RECALL -- SUNROOF HINGE