Talon FWD L4-1997cc 2.0L DOHC Turbo (1995)
3.
If a metallic clunk is heard when opening and closing the sunshade/sunroof, it is the rear shade hitting the sunroof drip channel or the drip channel
contacting the roof inner panel. Check the tightness of the drip channel screws. If they are loose, tighten them and recheck for a metallic clunk. If
the screws are tight or noise persists after tightening, place 2 Strips of the adhesive backed flocking, P/N 4773968, to two of the ribs on the rear
shade (Figure 4). Place each piece of flocking over the rib, extending slightly past the rear edge. Press the flocking down over each rib so it is
firmly attached.
Test operation. If noise still occurs, flocking can be added to the back side of the drip channel. Mark the 4 slide rail positions on the drip channel
(Figure 5). Remove drip channel and apply adhesive backed flocking, P/N 4773968, to the width of the channel where the slide rails pass.
Prior to reinstalling the drip channel, bend the first 15 mm (5/8") of both rear edges down to within 5 mm (13/64") of the channel base (Figure 6).
This will eliminate the channel from contacting the roof inner.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
Sunroof/Sunshade Effort Repair
23-10-30-90..........................................................................................................................................................................0.4 Hrs.
Sunroof/Sunshade Rattle Repair
23-10-30-91..........................................................................................................................................................................0.5 Hrs.
