Talon FWD L4-1997cc 2.0L DOHC Turbo (1995)
Drift Right Condition
Quantity
Part No.
Description
1
MR223123
Offset Compression Lower Arm Assembly - LH
1
MR223124
Offset Compression Lower Arm Assembly - RH
Drift Left Condition
Talon
Quantity
Part No.
Description
1
MR162583
Standard Compression Lower Arm Assembly - LH
Avenger/Sebring
Quantity
Part No.
Description
1
MR162581
Standard Compression Lower Arm Assembly - LH
REPAIR PROCEDURE:
This bulletin involves replacing the compression lower arm assembly(ies) based on the drift condition experienced.
1.
Raise the vehicle on a hoist.
2.
Following the procedure, the Caution, and the Removal Service Points listed in the applicable Service Manual. Remove both the right and left
compression arms for drift right or the left only for drift left (Figure 1).
NOTE:
SPECIAL TOOL MB991113 IS REQUIRED TO PERFORM THIS PROCEDURE.
3.
Install the new compression arm assembly(ies) in the reverse order. The offset arms have rounded ends and the standard arms have square ends
(Figure 2).
4.
Verify that the front toe adjustment and steering wheel center are correct. Adjust as required.
5.
Verify that the condition is corrected by road testing the vehicle on the same section of road used in step 3 under Diagnosis.