Talon FWD L4-1997cc 2.0L DOHC Turbo (1995)
9.
Apply 3M Double Sided Tape, p/n 06382 or equivalent, on the inner beltline weatherstrip the entire length where the molding contacts the door
trim (Figure 2).
10.
Remove the two inner stabilizer brackets.
NOTE:
MAKE SURE THE ADJUSTMENT SCREWS FOR THE STABILIZER BRACKETS DO NOT MOVE.
11.
Remove the two door glass up stops.
NOTE:
MARKING THE POSITION BEFORE REMOVING WILL HELP PREVENT MISADJUSTMENT OF THE GLASS UPON REINSTALLATION.
12.
Peel back the water shield to gain access to the glass screws.
13.
Remove the two bolts holding the glass to the window regulator and lift out the glass.
14.
Replace the glass guide on the front of the glass with a new glass guide, p/n MB321765 LH/MB321766 RH (Figure 3).
15.
Apply multi-purpose grease, p/n 4318063, to the front guide track where the plastic glass guide clip contacts the guide track.
16.
Install the glass to the window regulator.
17.
Reposition the water shield.
18.
Install speaker assembly, stabilizers, up stops, beltline molding, inner weather strip and the delta sash assembly.
19.
Confirm the glass setting, and adjust as necessary.
20.
Install door trim panel and confirm that the rattle has been eliminated.
