Talon FWD L4-1997cc 2.0L DOHC Turbo VIN F SMFI (1998)
Step 2 --- Air Bag Module (Driver's Side) Installation
Install the air bag module, taking care that the wiring is not pinched.
Post-installation Inspection
1. After installing the clock spring, the steering wheel, the column covers and the air bag module, check steering wheel for noise, binds or difficult
operation.
2. Reconnect the negative battery terminal. Turn the ignition key to the "ON" position. floes the "SRS" warning light illuminate for about 7 seconds,
turn OFF and then remain OFF? If yes, SRS system is functioning properly. See: Testing and Inspection.
INSPECTION
Air Bag Module Check
If any component damage is found during the following inspection, replace the air bag module with a new one. Dispose of the old one according to the
specified procedure. See: Service and Repair
CAUTION: Never attempt to measure the circuit resistance of the air bag module (squib) even if you are using the specified tester. If the circuit
resistance is measured with a tester, accidental air bag deployment will result in serious personal injury.
1. Check pad cover for dents, cracks or deformities.
2. Check the air bag module for dents, cracking or deformation.
3. Check hooks and connectors for damage, terminals for deformities, and harness for binds.
4. Check air bag inflator case for dents, cracks or deformities.