Vision V6-201 3.3L (1993)
Rear Door Panel: Service and Repair
REAR DOOR TRIM REMOVAL
CAUTION: Do not pry on door trim panel, damage to trim panel will result
Window Crank
1. Using a door handle removal tool, disengage clip holding window crank to regulator and separate crank from door, if equipped.
2. If wire harness must remain with door, disengage clips holding power window switch panel to trim panel and separate switch panel from door.
Disconnect wire connector from switch, if equipped.
3. If wire harness is to remain with door trim panel, disconnect door jamb connector. Remove fasteners holding wire harness close-out cover to door
end frame. Disengage push-in retainers holding door opening weatherstrip to door end frame. Pull harness from under weatherstrip.
Rear Door Trim Panel
4. Remove screw holding trim panel to door from behind inside latch handle.
5. Remove screw holding pull cup to door panel and separate pull cup from door. When installing pull cup, index arrow outward and snap pull cup
into trim panel.
6. Lift trim panel upward to disengage channel retainer at top of trim and tilt trim panel outward.