Vision V6-201 3.3L (1993)
Cruise Control Switch: Service and Repair
The speed control switches are mounted in the steering wheel and wired through the clock spring device under the steering wheel hub.
If removal of airbag module is necessary, refer to "Airbag Module" in the "Passive Restraint Systems" section.
1. Disarm airbag as described under "Airbag System Disarming."
2. Turn ignition switch to Off position.
3. Remove two screws from back side of each switch on steering wheel.
4. Rock switch away from airbag or horn pad while lifting switch out of steering wheel. Do not point airbag module toward yourself or others
when performing this operation to prevent injury in case of accidental deployment of airbag module.
5. Disconnect 2-way electrical connector.
6. Reverse procedure to install, sliding the forward edge of switch under airbag or horn pad. Line up locating pins on switch with holes in steering
wheel frame. Do not point airbag module toward yourself or others when performing this operation to prevent injury in case of accidental
deployment of airbag module.
