Vision V6-201 3.3L (1993)
Solar Sensor: Service and Repair
REMOVAL
1. Remove instrument top cover.
2. Remove Sun Sensor mounting screws.
3. Lift sensor out of instrument panel and disconnect wiring.
INSTALLATION
CAUTION: The sun sensor must protrude approximately 1/4 inch above the instrument panel top cover. This will ensure proper operation.
1. For installation, reverse the above procedures.
2. Some Automatic Temperature Control (ATC) equipped vehicles may exhibit a lack of passenger comfort in sunny weather. This will not occur in
night operation. This most likely occur in the early afternoon. Verify that the ATC system is functioning properly. Inspect the location of the sun
sensor. The sun sensor must protrude approximately 1/4 inch above the instrument panel top cover to insure proper operation. If the sensor does
not protrude 1/4 inch, perform the following procedure:
-
Confirm that the top cover is properly installed
-
Remove the top cover
-
Remove fasteners from sun sensor
-
Install one 1/4-20 nut per fastener under the sun sensor so that it is shimmed higher
-
Reinstall the sun sensor. Do not overtighten screw. If a longer screw is required, use 8-15x1 inch.
