Vision V6-201 3.3L (1993)
Ignition Coil: Description and Operation
Ignition Coil Operation (Coil Construction May Vary)
PURPOSE
The ignition coil pack is a component of the ignition system that is used to produce a voltage strong enough to jump the spark plug gap and ignite
the air/fuel mixture under all operating conditions.
CONSTRUCTION
The coil pack consists of three epoxy filled ignition coils molded together in one pack.
Each ignition coil consists of a primary winding, a secondary winding, and a soft iron core. The windings are embedded in an epoxy compound to
protect the coil from vibration damage.
The primary windings are made up of 2-3 hundred turns of heavy gauge wire, over the secondary windings. The secondary windings are made up
of 30-40 thousand turns of light gauge wire around a soft iron core.
OPERATION
Power is supplied to the positive side of coils by the ASD relay. Switching of the negative coil ground is controlled by the Powertrain Control
Module (PCM).
When the PCM grounds primary circuit, current flows through the primary windings, and a magnetic field is produced. As the magnetic field
builds it is concentrated in the soft iron core.
When the PCM opens the primary circuit ground from each coil, the magnetic field collapses. As the field collapses it passes through each turn of
the secondary windings, producing a small voltage in each turn. The voltage in each turn is multiplied by the number of wire turns.
Each coil fires two spark plugs on each power stroke. One coil fires the cylinder under compression, the other fire on the exhaust stroke.
