Vision V6-215 3.5L SOHC (1995)
Fig.4 Map Location
7. Disconnect electrical connector from Manifold Absolute Pressure (MAP) sensor and Throttle Position Sensor (TPS).
8. Disconnect purge hose from throttle bodies.
9. Disconnect Positive Crankcase Ventilation (PCV) make up air hose and idle air control motor supply hose then remove the air inlet plenum from
behind manifold.
10. Disconnect PCV, brake booster and remaining vacuum hoses from intake manifold.
11. Remove EGR tube mounting bolts at intake manifold plenum.
12. Remove air plenum support bracket on each side of manifold.
Fig.5 Intake Plenum Bolt Length Identification
13. Remove intake manifold plenum mounting bolts. The plenum uses two different length bolts.
14. Remove intake manifold plenum.
15. Remove upper radiator hose from thermostat housing and heater hose from rear of intake manifold.