Vision V6-3.5L VIN F (1997)
6.
Position a 1/2 box wrench over the retainer on the end of the parking brake cable. Compress cable housing retaining fingers and start housing
out of support plate. Remove wrench when retainer is free from the park brake cable mounting hole in the rear brake support plate. Alternate
method is to use a aircraft type hose clamp over housing end fitting compressing the three fingers.
Park Brake Cable Routing Clips
7.
Remove the 4 routing clips attaching rear park brake cable to floor pan and frame of vehicle.
8.
Move passenger side front seat to its full forward position.
9.
Remove the drivers side front seat assembly from the vehicle.
10.
Remove rear seat lower cushion from vehicle.
Park Brake Equalizer And Cover
11.
Remove both lower rear door opening sill moldings. This is required to allow rear section of carpeting to be folded forward. This will expose
the equalizer cover which is attached to the park brake cable reaction bracket.
12.
Remove the park brake equalizer cover from the reaction bracket.
NOTE: Do not remove the second rear park brake cable from the equalizer. If second park brake cable is removed from the equalizer, high
eftort will be required to connect the park brake cables to the equalizer.
