Vision V6-3.5L VIN F (1997)
1. Install the rocker arms, and pedestals onto the shaft.
2. Install dowel pins. Dowel pins pass through the pedestal into the exhaust rocker shafts. Dowel pins should be pressed in until they bottom-out
against the rocker shaft in the pedestal.
NOTE: Rocker arm and shaft assembly can be installed either prior to or after cylinder head installation.
INSTALLATION
1. Rotate camshafts to the position shown in the illustration. With the camshafts in these positions the lobes are in a neutral position (no load to the
valve). This will allow the rocker arm shaft assembly to be tightened into position with little or no valve spring load on it.
2. Install the rocker arm and shaft assembly making sure that the identification marks face toward the front of engine for left head and toward the rear
of the engine for right head.
3. Tighten bolts in sequence to 31 Nm (275 inch lbs.).
