Vision V6-3.5L VIN F (1997)
Air Bag Control Module: Service and Repair
Six Passenger Vehicle
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove two lower center cover retaining screws and remove trim cover.
3. Disconnect ACM 4-way and 13-way connectors.
4. Remove two module mounting screws and remove module.
INSTALLATION
1. Position ACM (arrow pointing forward) in the instrument panel center support bracket, engaging the module into the clip on the instrument panel
bracket.
2. Attach the ACM to the support bracket with the two screws supplied and tighten to 5.5 to 9.5 N.m (49 to 84 in. lbs.) torque.
CAUTION: Use supplied screws only
3. Connect ACM connectors and ensure connectors and locking tabs are engaged.
4. Install trim cover and secure with two screws.
5. Do not connect battery negative cable. Refer to Testing and Inspection/Procedures for Airbag System Test procedures.