Vision V6-3.5L VIN F (1997)
6.
Follow the steps presented on the MDS and DRB III(R) which will allow the DRB III(R) to obtain the current part number of the PCM or TCM.
7.
The MDS will display the part number of the PCM or TCM on the vehicle and the appropriate replacement part number, then press NEXT MENU
to begin programming.
If the PCM or TCM on the vehicle has already been updated or programmed, a NO UPDATES AVAILABLE message will be displayed. Check
the part number of the PCM or TCM on the vehicle and compare it to the part number displayed. If the PCM or TCM has already been updated,
then another condition exists that will require further diagnosis and repair.
8.
The MDS and DRB III(R) will prompt for any operator action needed during the remainder of the programming process.
9.
Repeat steps 1 through 8 to reflash the TCM.
NOTE:
THE FOLLOWING STEPS ARE REQUIRED BY LAW.
10.
Type the necessary information on each "Authorized Software Update Label" p/n 04669020 (Figure 1). Attach one label to the PCM and the other
to the TCM. Cover each label with the clear plastic overlay.
11.
Type the necessary information on the "Authorized Modification Label" p/n 04275086 and attach the label near the VECI Label (Figure 2).
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
08-19-40-90
Powertrain Control Module Reprogram
0.5 Hrs.
Labor Operation No:
08-19-50-94
Transmission Control Module Reprogram
0.5 Hrs.
FAILURE CODE: FM - Flash Module
