Aerostar V6-183 3.0L (1986)
Step 10
Bundle excess wire (see Diagram 5) and retain with Tie Down located in fuse package.
Step 11
Connect 12-way connector to mating vehicle 12-way connector removed in step 2. Inspect and insure that all corresponding terminals align properly.
Push until retainer locks-into place.
Step 12
Using a voltmeter and probe, test the terminal for voltage at point "X" (Diagram 5). If voltage is present go to step 13. If no voltage is present check
previous connections for proper location (refer to steps 5, 7, 8 and 11), and or fuse for possible open circuit.
Step 13
Reinstall the Trailer Tow Relay and Bracket Assembly using the single attaching screw.
Step 14
Reinstall Jack Assembly and trim cover.
Step 15
Dealers should either give the label page number and the label, found in the fuse repair kit, to the owner or wet the glue backing and attach the label to
the Aerostar Owners Guide on the following page:
INSTALL LABEL AT
YEAR
BOTTOM OF PAGE
1986
156
1987
181
1988
179
NOTE:
In those cases where the page number changed with the second or third printing of the Owner Guide, attach the label at the bottom of the last
fuse chart in the Specifications and Capacities Section of the guide.
If the Owner Guide is missing, give the label to the owner.
Technical Information
July, 1988
Dear Owner:
This notice is sent to you in accordance with the requirements of the National Traffic and Motor Vehicle Safety Act.
Ford Motor Company has determined that a defect which relates to motor vehicle safety exists in certain 1986-1988 Aerostars equipped with optional
trailer tow packages.