ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Brake Caliper|Front|Page 4630 > < Brake Caliper|Front|Page 4628
Page 1
background image

Brake Caliper: Service and Repair
Removal

NOTE:  If the front disc brake calipers are to be removed for service other than to replace brake shoes, fluid removal from the brake master cylinder
(2140) may not be required.
Removing some fluid will prevent fluid from overflowing from the brake master cylinder when the wheel cylinder piston are pressed into their bores.

CAUTION:  System contamination may result if anything other than a clean device is used to remove fluid from brake master cylinder. 

REMOVAL

1. Use a clean siphon or suction hose to remove a portion of the fluid from the brake master cylinder. Discard the removed fluid.
2. Raise the vehicle and install safety stands. Remove a front wheel and tire assembly.

CAUTIONS:
^

Do not position C-clamp on the brake shoe hold down spring. Also, do not compress wheel cylinder piston further than is required to
disengage torque buttons from front disc brake caliper. Damage to the brake shoe hold down spring will result. Replace shoe if brake shoe hold
down spring is bent or damaged.

^

Do not attempt to "bottom" the wheel cylinder piston in the bore at this time. Use an old, worn out brake shoe or block of wood and the
C-clamp to bottom the wheel cylinder piston once the front disc brake caliper is removed from front disc brake rotor, and the shoes are
removed from the front disc brake caliper.

 

3. Use an eight-inch C-clamp to move the wheel cylinder piston back into its bore as follows:

a. Place the head of the C-clamp against the front disc brake caliper, and the screw end of the C-clamp against the outer shoe below the spring

clip.

b. Tighten the clamp until the torque buttons just clear the caliper (about 3mm [1/8 inch]). Remove the C-clamp.
c. Do not use a screwdriver or similar tool to pry the wheel cylinder piston away from the front disc brake rotor.

4. Clean excess dirt from area around pin tabs.
5. Using Caliper Pin Remover D89T-2196-A or equivalent and a light hammer, drive the caliper pin from the front disc brake caliper as follows:

Brake Caliper|Front|Page 4630 > < Brake Caliper|Front|Page 4628