Aerostar 2WD V6-182 3.0L (1995)
Control Assembly: Service and Repair
Climate Control Switches
Climate Control Assembly Switch
Removal and Installation
1.
Disconnect battery ground cable.
2.
Remove heater control from instrument panel as described in this section.
3.
Remove the knob from the heater blower motor switch.
4.
Pull the heater control through the instrument panel opening far enough to allow removal of the electrical connector.
5.
Remove the electrical connector from the heater blower motor switch by lifting the snap-lock retainer with a screwdriver. Pull on the connector
until it separates.
6.
Remove the hex-head screw which attaches the heater blower motor switch to the bracket of the heater control and remove the heater blower
motor switch.
For installation, follow removal steps in reverse order. Check system for proper operation.
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module
(PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.