Aerostar 2WD V6-182 3.0L (1995)
Hose/Line HVAC: Service and Repair
Refrigerant Lines
Removal
1.
Remove the refrigerant from the system following the recommended procedure. Observe all safety precautions.
2.
Disconnect and remove the refrigerant line(s) using a wrench on each side of the fitting.
Installation
1.
Route the new refrigerant line(s) (with protective caps installed).
2.
Connect the refrigerant line into the system using new 0-rings lubricated with clean refrigerant oil. Use two wrenches to tighten the threaded
fitting to the specified 21-27 N.m (15-20 lb-ft) or connect the A/C tube lock coupling clip in accordance with the proper procedure.
3.
Leak test, evacuate and charge the refrigerant system. Observe all safety precautions.
4.
Check the air conditioning system for proper operation.
