Aerostar 2WD V6-3.0L VIN U (1997)
6. Install the solenoid clamp with solenoid clamps-to-main control screws. Tighten to 6-8 Nm (53-71 inch lbs.).
CAUTION: The solenoid bracket must be installed in the TCC and EPC solenoid grooves, shift solenoid pockets and the No. 204 plug.
7. Install connectors on solenoids.
8. Install filter.
9. Install new fluid pan gasket onto pan.
10. Install pan.
11. Fill the transmission to the proper level.
Assembly
1. Install the EPC limit circuit screen. Push down on the EPC limit circuit screen to make sure it is fully seated.
CAUTION: Make sure that the screen is properly located.