Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Figure 20
2.
Cut the green wire two inches past (toward the dash panel) the fuse links to terminate the feed circuit at this point. Fold back the cut end of
the wire which goes inside the vehicle and tape wrap with (D6AZ-19627-A) pressure-sensitive waterproof tape, Figure 20.
3.
Tape wrap the entire area to prevent unraveling.
4.
At the remaining cut end of the Green wire, which connects to the starter relay, strip away 3/8 inch of insulation followed by installing a butt
splice connector (E6FZ-14488-C), using a standard crimp tool and a heat gun, Figure 20.
5.
Strip away 3/8 inch of insulation from one end of the roll of 10 gauge (Black) wire and install into the other end of the butt splice connector
and crimp in place, Figure 20, View A.
